Evinrude 6HP Outboard Motor

This used Evinrude 6 HP is a small, single-cylinder outboard meant for dinghies, jon boats, and use as a spare, steered by its own tiller handle and started with a pull rope. Engine Bore and stroke of 2.32 in by 1.77 in give this carbureted 1-cylinder block 7.5 cubic inches (123 cc) of displacement, and full throttle runs the 2.15:1 final gear through 5000-6000 rpm. Who it suits At 55 lbs, it's light enough to carry, clamp on, and store without hoisting gear, which makes it a practical kicker motor or backup for days when a bigger engine isn't needed, and simple enough for an inexperienced boater to manage solo. What to check before buying This unit rides a 15-inch shaft, so confirm that length against your transom before ordering. As a used motor, cosmetic wear and service history will vary by unit, and trim here is adjusted manually rather than by a power system, so there's no hydraulic or electric hardware to inspect. Standard fit The exhaust path runs through the prop to hold the noise down, the fuel tank is built into the housing rather than fitted separately, and the tiller handle carries the throttle and shift controls together. Is this electric start? No, it starts by pull rope. What's the shaft length? 15 inches. How much does it weigh? 55 lbs.